relief grinding

Relief Grinding of Relieving Form Cutter for Manufacturing Spiral Flute

加工螺旋槽的铲齿成形铣刀的铲磨

At present, traditional processes of hob are radial relief grinding in general, when we adopt this process, it will cause tooth flanks distortion, reduce hob proper tooth profile, and be lead to hob accuracy lower, which restricts gear hobbing level further seriously.

目前滚刀一般采用径向铲磨方式进行精加工，由于径向铲磨会造成齿侧面畸变，减小齿形合格长度，导致滚刀精度寿命低，径向铲磨工艺严重制约着滚齿加工水平的进一步提高。

The Design of Small Diameter and Extend Length Hard Alloy Relief Grinding Hobs and Regrinding

小直径加长硬质合金铲磨滚刀的设计及其重磨

Research on the Method of Accurate Relief Grinding for Making Gear Hobs

齿轮滚刀齿侧面精密铲磨的方法研究

When designing gear hob, worm gear hob and shaping milling cutter, it should be verified whether the interfere would occur between grinding wheel and the next gear tooth on condition of pledging the relief grinding length of the back of tooth.

在设计齿轮滚刀、蜗轮滚刀和成形铣刀时，要校验在保证齿背铲磨长度的情况下，所用砂轮是否和下一个齿发生干涉。

Mirror Micro Relief Grinding Mechanism of TiC Series Steel Matrix Carbide Alloys Float · Swim

TiC系钢结硬质合金镜面微浮凸磨削机理的研究